CYLINDER ASSEMBLY REPLACEMENT
Replaceable camshaft bearing halves should remain with the cylinder.
When carbon deposits make removal of piston pin difficult, tap end of
piston pin using a brass drift and ball peen hammer.
10. Remove piston (6) from connecting rod (9).
a. Remove two piston pin retaining rings (11) using retaining ring pliers (item 81, WP 0176).
b. Remove piston pin (10) from piston, and remove piston (6) from connecting rod (9).
c. Reinstall piston pin (10) in piston after it is removed from the connecting rod.
d. Secure piston pin (10) in piston with two retaining rings (11).
11. Remove and discard O-ring (12) from cylinder assembly.
Do not remove crankcase protectors (item 25, WP 0176) until crankshaft and
connecting rods have been removed. Damage to crankcase can occur.
WP 0133 00-7