OIL SEAL HOUSING ASSEMBLY AND ASSOCIATED PARTS
3. Remove oil seal (12) from crankshaft (13).
a. Remove spring (14) from lip in oil seal (12) and slide it out of the way.
b. Remove split oil seal (12) from crankshaft (13).
c. Position spring (14) so ends can be seen.
d. Twist male end of spring (14) clockwise and female end counterclockwise and remove
spring from crankshaft.
e. Discard oil seal and spring.
1. See Work Package 0028 for General Cleaning Procedures.
All parts must be inspected with care. Replace parts if damage or wear exceeds allowable
1. See Work Package 0028 00 for General Inspection Procedures.
The oil seal housing and cap are machined with the engine crankcase
and are mating parts. Always keep the oil seal housing and cap as an
assembly with the crankcase. Failure to comply may result in
premature failure of the oil seal.
WP 0136 00-4