DAMPER/OIL FILTER HOUSING ASSEMBLY REPLACE/REPAIR
1. Remove damper/oil filter housing (1).
a. Remove 12 screws (2) with flat
washers (3) securing damper/oil filter
housing (1) to oil pan (4).
b. Remove self-locking nuts (5) with flat washers (6). Discard self-locking nuts.
c. Attach suitable lifting sling and hoist to lifting eyes (7).
Damper/oil filter housing is heavy, use suitable lifting device. Take
care that damper/oil filter housing does not swing on hoist and injure
Do not allow damper/oil filter
housing to rest on studs after
housing is separated from
crankcase and oil transfer tubes.
Caution must be taken to prevent
damage to machined surfaces on
and the damper/oil filter housing.
d. With a slight amount of lifting pressure
from hoist, carefully remove the
damper/oil filter housing (1).
5 (fourteen places)
WP 0151 00-2