DAMPER/OIL FILTER HOUSING ASSEMBLY REPLACE/REPAIR
1. Install damper/oil filter housing (1) (Continued):
c. Apply a 1/16- to 1/8-inch bead of sealant (item 33, WP 0173) at the split line (A) and the
mating surfaces of the damper housing (1) and the crankcase assembly (40).
d. Attach suitable lifting sling (item 105, WP 0176) and hoist to lifting eyes (7).
Damper/oil filter housing is heavy, use suitable lifting device. Take
care that damper/oil filter housing does not swing on hoist and injure
Do not allow damper/oil filter housing to rest on studs while housing
is separated from crankcase and oil transfer tubes.
Caution must be taken to prevent damage to machined surfaces on
e. Lift damper/oil filter housing (1) just enough to clear oil pan (4) and carefully slide into
WP 0151 00-12