OIL PUMP REPLACEMENT
1. Remove and discard gasket (1) from leveling transfer tube (2).
2. Remove transfer tube (2).
a. Remove two self-locking nuts (3) and two screws (4). Discard self-locking nuts (3).
b. Disengage and remove transfer tube (2) from hole in baffle (5) and from opening in oil
c. Remove and discard O-ring (7).
Lock wire used here
Older engines had lock wire
securing screws that fasten the
pump to the crankcase. Lock wire
is no longer required in this
However, lock wire is still used on
the two screws securing support
Lock wire no
longer used here
WP 0153 00-2