Quantcast INSPECTION (Continued) - TM-9-2815-220-241339

Custom Search
 
  
 
TM 9-2815-220-24
STARTER DRIVE MECHANISM REPAIR
0157 00
INSPECTION (Continued)
5. If bearings (20) were removed, measure outside diameter of bearing hubs (A) on spur gear
shaft (7). Replace spur gear shaft if not within specifications in the following table.
a. New bearing dimensions, inside (B) and outside (C), are provided for information purposes
only; you need not perform the measurements.
Location
Sizes and Fit of New Parts
Wear Limits
inches (mm)
A (bearing hubs)
1.3781 (35.0037)
1.3785 (35.0139)
1.3779 (34.9986)
B (bearing inside)
1.3775 (34.9885)
1.3780 (35.0012)
None
C (bearing outside)
2.8341 (71.9861)
2.8346 (71.9988)
None
C
20
A
7
B
A
WP 0157 00-7

 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc.