ACCESSORY DRIVE HOUSING REPLACE/REPAIR
3. Remove automatic fuel injection advance control (16).
a. Remove and discard eight cotter pins (17).
Bearing cap and housing are machined as a unit. Cap must be kept
with housing. Both cap and accessory housing assembly are stamped
with corresponding numbers to prevent incorrect mating of parts.
Cap should be loosely attached on accessory housing assembly after
automatic fuel injection advance control is removed.
b. Remove two slotted nuts (18) with flat washers (19) securing bearing cap (20).
c. Remove cap (20) from accessory drive housing (9).
WP 0158 00-5