Quantcast INSPECTION (Continued) - TM-9-2815-220-241431

Custom Search
 
  
 
TM 9-2815-220-24
REAR FAN DRIVE REPAIR
0168 00
INSPECTION (Continued)
CAUTION
If either the fan drive or driven bevel gear shaft require replacement,
both must be replaced. They are a matched set and cannot be
replaced individually.
4. Measure outside diameter (A) of bearing surface on [driven] bevel gear shaft (8). Replace
bevel gear shaft if not within specifications in the following table.
Location
Sizes and Fits of New Parts inches (mm)
Wear Limits
A (bearing surface)
1.5749 (40.0025)
1.5753 (40.0126)
1.5747 (39.9973)
8
A
5. Measure outside diameters (B, C) of [drive] bevel gear shaft (4). Replace bevel gear shaft if
not within specifications in the following table.
Location
Sizes and Fits of New Parts inches (mm)
Wear Limits
B (outside diameter)
1.5749 (40.0025)
1.5753 (40.0126)
1.5747 (39.9973)
C (outside diameter)
1.6244 (41.2597)
1.6248 (41.2699)
1.6242 (41.2547)
4
4
B
C
WP 0168 00-5

 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc.