TM 9-2815-225-34&P
3-36. VIBRATION DAMPER AND CRANKSHAFT PULLEY REPAIR
THIS TASK COVERS:
a. Cleaning
b. Inspection
INITIAL SETUP:
APPLICABLE MODELS
TROUBLESHOOTING REFERENCES
All
Para. 2-8
SPECIAL TOOLS
EQUIPMENT CONDITION
None
Vibration damper and crankshaft pulley removed
(para. 3-14).
TEST EQUIPMENT
None
SPECIAL ENVIRONMENTAL CONDITIONS
Work area clean and away from blowing dirt and
MATERIALS/PARTS
dust.
Solvent, SD-3 (Appendix C, Item 30)
Developer, spotcheck, SKD-NF
GENERAL SAFETY INSTRUCTIONS
(Appendix C, Item 10)
Always wear eye protection when working with
Cloth, emery, 290-grit (Appendix C, Item 5)
compressed air.
Use solvents away from flame and in well-venti-
PERSONNEL REQUIRED
lated area.
Automotive repairman MOS 63H
REFERENCES (TM)
None
LOCATION/ITEM
ACTION
REMARKS
a. Cleaning
WARNING
Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use only
with effective chip guarding and protective equipment such as goggles or shield, gloves,
etc. Failure to comply may result in injury to personnel.
Approved solvents may be flammable and will not be used near open flame. Use only in
well-ventilated area. Failure to comply may result in injury to personnel.
1.
Vibration damper (1)
Clean with solvent SD-3 and
Refer to para. 3-6 for
and crankshaft
dry with compressed air.
additional cleaning
pulley (2)
instructions.
b. Inspection
2.
Crankshaft pulley (2)
Inspect for cracks, breaks,
Discard if damaged.
and other damage.
3.
Vibration damper (1)
a. Inspect for cracks, breaks,
Discard if damaged.
bends, and other damage.
3-148
|
|
