TM 9-2815-225-34&P 3-40. CAMSHAFT CAM FOLLOWER, AND PUSHROD REPAIR (Contd) LOCATION/ITEM ACTION REMARKS c.  Inspection (Contd) 18. Cam follower (8) or (9) Using suitable micrometer, Discard intake and exhaust cam measure roller pin bore. follower (8) if roller pin bore is not within 0.4990 and 0.4995 in. (12.675 and 12.687 mm).  Discard injector cam follower (9) if roller pin bore is not within 0.6992 and 0.6997 in. (17.760 and 17.772 mm). d.  Assembly 19. Cam follower roller (19) and a.  Install roller (19) on cam roller pin (17) follower (8) or (9). b.  Hold 0.006 in. (0.152 mm) feeler gauge between cam follower (8) or (9) and cam follower roller (19). c.  Install roller pin (17) on cam follower (8) or (9) and cam follower roller (19). d.  Secure roller pin (17) to cam follower (8) or (9) with roll pin (18). NOTE Repeat steps 20 through 22 for each cam follower assembly. 20. Four intake and exhaust Install on cam follower housing Ensure injector cam cam followers (8), two (13). follower (9) is in center position, injector cam followers (9), and that cam follower pushrod and two cam follower sockets are on same side as dowel shafts (12) holes in housing. 21. Cam follower shaft (12) Install dummy screw. Dummy screw is used to prevent breaking shaft locking screw (10) when expansion plugs (11) are installed on cam follower housing (13). 3-204