TM 9-2815-225-34&P 3-52. FUEL INJECTOR REPAIR (Contd) LOCATION/ITEM ACTION REMARKS d.  Assembly (Contd) CAUTION Do not allow plunger to fall out when holding injector assembly with cup facing up. d.  With one hand, turn injector If plunger (2) does not slide out assembly (1) so injector cup (10) immediately, injector assembly faces upward.  Plunger (2) should (1) is not aligned and must be slide out immediately. reassembled as outlined in steps 19 through 25. 26. Three new gaskets (8) Install on grooves. 27. New gasket (16), filter Install on top-stop adapter (7). Replace gasket (16) if required. screen (15), and filter screen clip (14) NOTE After assembly, store injector in a clean place until ready for testing and calibration. 28. Injector spring (6) and Install on plunger (2) and insert Do not install top-stop locknut (4) washer (5) in top-stop adapter (7) on and top-stop screw (3) at this injector assembly (1). time.  Store with injector assembly (1). FOLLOW-ON TASK:  Perform fuel injector testing; Test No.  1 (para. 3-53). 3-350