TM 9-2815-225-34&P 3-13. MOUNTING ENGINE ON MAINTENANCE STAND THIS TASK COVERS: a.  Lifting d.  Inspection b.  Draining e.  Component Removal c.  Cleaning f.  Mounting to Maintenance Stand INITIAL SETUP: APPLICABLE CONFIGURATIONS TROUBLESHOOTING REFERENCES All para. 2-8 SPECIAL TOOLS EQUIPMENT CONDITION Engine lifting fixture (15434) ST-125    Engine removed from vehicle (TM 9-2320-273-34 Engine stand (NSN 1740-00-338-6673) or or TM 9-2320-283-34). suitable stand    Starter motor and solenoid removed (TM 9-2320-273-20 or TM 9-2320-283-20). TEST EQUIPMENT    Alternator, belts, and bracket removed None (TM 9-2320-273-20 or TM 9-2320-283-20). MATERIALS/PARTS SPECIAL ENVIRONMENTAL CONDITIONS Solvent, SD-3 (Appendix C, Item 30) Work area clean and away from blowing dirt and Cap and plug set (Appendix C, Item 31) dust. Six gaskets (15434) 3020943 Eight lockwashers (15434) 109594 GENERAL SAFETY INSTRUCTIONS Six lockwashers (96906) MS35338-48    All personnel must stand clear during lifting oper- Two lockwashers (96906) MS35338-46 ations. Six lockwashers (15434) S-604    Use extreme caution during disassembly; engine Gasket (15434) 3031858 components are heavy. Gasket (15434) 3008017    Diesel fuel is flammable. Gasket (15434) 70089-1    Use approved solvents in well-ventilated area. Six preformed packings (15434) 3007442 PERSONNEL REQUIRED Automotive repairman MOS 63H REFERENCES LO 9-2320-273-12 TM 9-2320-273-20 TM 9-2320-273-34 LO 9-2320-283-12 TM 9-2320-283-20 TM 9-2320-283-34 LOCATION/ITEM ACTION REMARKS a.  Lifting WARNING All personnel must stand clear during lifting operations.  A snapped chain or swinging or shifting load may result in injury to personnel. 1. Dressed engine assembly (1) a.  Connect engine lifting fixture (2) to two engine lifting brackets (3). 3-10