TM 9-2815-225-34&P 3-57.  SOLENOID VALVE REPAIR THIS TASK COVERS: a.  Removal d.  Inspection b.  Disassembly e.  Assembly c.  Cleaning f.  Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All None SPECIAL TOOLS TROUBLESHOOTING REFERENCES None Para. 2-8 TEST EQUIPMENT EQUIPMENT CONDITION None Fuel pump removed (para. 3-16). MATERIALS/PARTS SPECIAL ENVIRONMENTAL CONDITIONS Cloth, lint-free (Appendix C, Item 6) Work area clean and away from blowing dirt and Solvent, SD-3 (Appendix C, Item 30) dust. Oil, lubricating, OE/HDO 30 (Appendix C, Item 21) GENERAL SAFETY INSTRUCTIONS Rectangular ring seal (15434) 129888    Always wear eye protection when using com- Rectangular ring seal (15434) 154087 pressed air. O-ring seal (15434) 190876    Use approved solvent in well-ventilated area and Two lockwashers (15434) 181466 away from open flame. PERSONNEL REQUIRED Fuel and electrical systems repairman MOS 63G LOCATION/ITEM ACTION REMARKS a.  Removal 1. Two screws (1), lockwashers Remove from fuel pump (17). Discard rectangular ring seal (16) (2), washers (3), solenoid and lockwashers (2). valve (4), and rectangular ring seal (16) b.  Disassembly 2. Four solenoid mounting Remove electrical solenoid (6) screws (5) from valve body (14). 3. Shutoff valve shield (7), Remove from valve body (14). Discard rectangular ring seal (8). rectangular ring seal (8), shutoff valve spring (9), and valve disk (10) 4. Shutoff valve knob (15) Remove from shutoff valve shaft This is done by turning knob and (12). shaft clockwise.  Threads on shaft will act as a puller. 5. Shutoff valve shaft (12), Remove from valve body (14). Discard O-ring seal (11). plug (13), and O-ring seal (11) 3-388