TM 9-2815-225-34&P 3-63. FUEL PUMP TESTING AND CALIBRATION (Contd) LOCATION/ITEM ACTION REMARKS c.  Mounting Fuel Pump to Test Stand (Contd) NOTE Scribe position of throttle shaft and throttle lever before removing. 7. Jamnut (63), washer (64), Remove from throttle lever (48). and screw (65) 8. Throttle lever (48) Remove from throttle shaft (50). 9. Throttle shaft cover (52) Remove from fuel pump main housing (51). 10. Throttle shaft (50) a.  Install on throttle lever (48). b.  Install and tighten screw (65), washer (64), and jamnut (63). 11. Test stand adapter a.  Install on test stand Word "TOP" (or adapter ring ring (67) adapter bracket (66). part number) must be visible on top side of ring (67) when assem- bled. b.  Secure with four screws (69) and washers (68). 12. Test stand adapter ring a.  Install on test stand mounting (67) and test stand rails (12). adapter bracket (66) (assembled) b.  Secure to rails (12) with clamp Tighten clamp bar (70) finger- bar (70). tight only at this time. 3-468