TM 9-2815-225-34&P 3-17.  AIR COMPRESSOR REMOVAL THIS TASK COVERS: Removal INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-273-34 TM 9-2320-283-34 SPECIAL TOOLS Air compressor wrench (15434) 3375159 TROUBLESHOOTING REFERENCES Para. 2-8 TEST EQUIPMENT None EQUIPMENT CONDITION    Fuel pump removed (para. 3-16). MATERIALS/PARTS    Air compressor governor removed Four lockwashers (12204) 116122 (TM 9-2320-273-34 or TM 9-2320-283-34). Two lockwashers (96906) MS35338-45 Gasket (15434) 157911 SPECIAL ENVIRONMENTAL CONDITIONS Gasket (15434) 3005962 Work area clean and away from blowing dirt and dust. PERSONNEL REQUIRED Automotive mechanic MOS 63H GENERAL SAFETY INSTRUCTIONS None LOCATION/ITEM ACTION REMARKS Removal NOTE Removal  of  air  compressor  coolant  lines,  air  lines,  and  fittings  is  basically  the  same  for M915/Big Cam I and M915A1/Big Cam III engines.  The M915A1/Big Cam III is shown. 1. Coolant inlet tube (5) and Disconnect and remove from Remove and discard bushings coolant outlet tube (1) three adapters (3) and elbow (7). (2) if damaged. 2. Three adapters (3), elbow Remove from compressor (4) (7), and coupling (6) and aftercooler. 3. Air inlet hoses (9) and tube Loosen four clamps (10), and (11) remove from air inlet connector (16) and elbow (8). 4. Screws (12) and (15), two Remove from compressor (4). Discard lockwashers (13) and lockwashers (13), washers gasket (18). (14), plug (17), air inlet connector (16), and gasket (18) 3-36