TM 9-2815-225-34&P 3-88.  REMOVING ENGINE FROM MAINTENANCE STAND (Contd) LOCATION/ITEM ACTION REMARKS b.  Component Installation NOTE   Perform steps 3 and 4 for M915/Big Cam I only.   Perform steps 5 through 7 for M915A1/Big Cam III only. 3.   New gasket (9), flange (8), Install on cylinder block (6). and six screws (7) 4.   Water transfer tube (12), Install on flange (8). two water transfer hoses (11), and four clamps (10) 5.   Two new gaskets (13), Install on cylinder block (6). water header covers (14), and twelve captive washer screws (15) NOTE Do not soak piston cooling nozzle O-rings in lubricating oil for any length of time or O-rings will swell. 6.   Six new preformed Lubricate with OE/HDO 10 Ensure piston cooling nozzles (17) packings (16) lubricating oil and position on are not twisted in groove. six piston cooling nozzles (17). 7.   Six piston cooling nozzles Install on cylinder block (6).   Tighten to 140 lb-in. (16 Nm). (17) and self-locking screws (18) 8.   Power steering pump Install. Refer to TM 9-2320-273-20 or and reservoir TM 9-2320-283-20. 9.   Water pump and drivebelts Install. Refer to TM 9-2320-273-20 or TM 9-2320-283-20. 10.    Fan brace, bracket, and Install. Refer to TM 9-2320-273-20 or spacers TM 9-2320-283-20. 11.    Fan, fan clutch, and fan Install. Refer to TM 9-2320-273-20 or clutch drivebelts TM 9-2320-283-20. 12.    Engine wiring harness Install. Refer to TM 9-2320-273-20 or TM 9-2320-283-20. 13.    Ether quick-start cylinder, Install. Refer to TM 9-2320-273-20 or valve, safety switch, and TM 9-2320-283-20. thermostat 3-662