(12) Mount Engine in Engine Rebuild Stand.
(a) Remove capscrews and lockwashers securing forward water header cover to cylinder block, and remove
cover and gasket. Discard gasket.
(b) Secure both header plate adapters to header ports on right side of engine.
Adapter plate must be installed with word "TOP" facing up.
(c) Position engine-to-rebuild stand adapter plate with spacers over water header adapter plates, and secure in
position with capscrews and lockwashers.
DIRECT PERSONNEL TO STAND CLEAR DURING HOISTING
FAILURE TO DO THIS MAY CAUSE INJURY TO PERSONNEL.
(d) Lift engine and mate adapter plate with circular mount plate on engine rebuild stand.
(e) Bolt adapter plate and circular mount plate together with bolts, washers, and nuts.
(f) Remove lifting device.
3-30 Change 1