Keep rod caps and mating rods together. Do not intermix parts. Caps and rods
are matched assemblies.
(h) Remove capscrews and rod caps with lower bearing half.
(i) Install two connecting rod guide pins.
CAREFULLY PUSH CONNECTING ROD AND PISTON ASSEMBLIES FROM LINERS
TAKING CARE NOT TO SCORE OR GOUGE LINER WALLS.
ASSISTANT SHOULD BE USED IN REMOVAL OF PISTON AND CONNECTING ROD
(j) Carefully pus h connecting rod and piston assemblies from cylinder liners, holding pistons so they will not
(k) Check each rod and cap to ensure it is stamped and labeled.
(l) Remove rod upper bearing half and assemble each connecting rod to its mating rod cap.
(m) Tape mating connecting rod bearing halves together and label each pair by cylinder.
(n) Using piston ring expander, remove and discard piston rings.