2-13.1.   ENGINE REPLACEMENT IN SHIPPING/STORAGE CONTAINER This task covers: a.    Removal b. Installation INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix E, Item 1) Special Tools Engine lifting sling  (Appendix E, Item 3) Materials/Parts Eight lockwashers (Appendix D, Item 26.1) Manual References TM 9-2815-237-34P Personnel Required One mechanic One assistant General Safety Instructions Direct personnel to stand clear during hoisting operation. TM 9-2815-237-34 2-6.2 Change 1 a.  Removal 1. If engine container (5) is closed and sealed, press air-release button (1) located at center of breather valve (2) before opening engine container (5). 2. Remove twenty-six nuts (19), washers (18), capscrews (16), and upper container (4) from lower container (13). 3. Position engine lifting sling on engine assembly (6) and install sling on right cylinder head (25) with two capscrews (24). 4. Install sling bracket (21) to engine lifting sling with pin (22) and on left cylinder head (20) with two capscrews (23).  Tighten capscrews (23). 5. Remove four capscrews (14), lockwashers (8), and washers (7) from two engine mounts (12). Discard lockwashers (8). 6. Remove four capscrews (9), lockwashers (8), and washers (7) from two rear engine mounts (10). Discard lockwashers (8). WARNING Direct personnel to stand clear during hoisting operation. Failure to do this may cause injury to personnel. 7. Attach hoist to engine lifting sling and remove engine assembly (6) from lower container (13). 8. Position engine on repair stand (para. 2-14). b.  Installation 1. Install engine assembly (6) in lower container (13). 2. Install engine assembly (6) on two rear engine mounts (10) with four washers (7), lockwashers (8), and capscrews (9). 3. Install engine assembly (6) on two engine mounts (12) with four washers (7), lockwashers (8), and capscrews (14). 4. Remove pin (22) from sling bracket (21). 5. Remove two capscrews (24) and lifting sling from right cylinder head (25). 6. Remove two capscrews (23) and sling bracket (21) from left cylinder head (20). 7. Visually check humidity indicator (17) for discolorization. If indicator (17) is dark purple, replace desiccant (3).