TM 9--2815--247--34 0028 00--1 OIL FILTER CRANKSHAFT DAMPER HOUSING ASSEMBLY REPAIR 0028 00 THIS WORK PACKAGE COVERS: Disassembly, Inspection, Repair, Assembly INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 19, WP 0103 00) Slide hammer (item 27, WP 0103 00) Valve sleeve remover (item 3, WP 0104 00) Outside micrometer caliper set (item 9, WP 0103 00) Telescoping gauge set (item 16, WP 0103 00) Spring tester (item 46, WP 0103 00) Safety goggles (item 28, WP 0100 00) Materials/Parts Gasket (item 15, WP 0102 00) Gasket (item 34, WP 0102 00) Self--locking nuts (2) (item 41, WP 0102 00) Equipment Conditions Engine level on flat surface (WP 0021 00) Engine cleaned and drained (TM 9--2350--292--20) Power take--off housing and associated parts removed (WP 0035 00) Right side engine oil cooler hoses removed (TM 9--2350--292--20) References TM 9--2350--292--20 Disassembly WARNING The access cover is spring--loaded. Exercise care when removing cover. Failure to comply may result in person- nel injury from flying parts. 1.   Remove two self--locking nuts (1), and two flat washers (2). Discard self--locking nuts. 2.   Remove access cover (3), gasket (4), valve stop plate (5) and spring (6). Discard gasket. Figure 13 1 2 3 4 5 6