TM 9--2815--247--34 0031 00--1 INTAKE MANIFOLD AND AFTERCOOLER ASSEMBLY REPLACEMENT 0031 00 THIS WORK PACKAGE COVERS: Removal, Disassemby, Assembly, Installation INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 19, WP 0103 00) Materials/Parts Gaskets (6) (item 30, WP 0102 00) Self--locking nuts (23) (item 49, WP 0102 00) Sleeve (item 137, WP 0102 00) Sleeves (2) (item 136, WP 0102 00) Grommets (3) (item 36, WP 0102 00) Lubricant (item 12, WP 0100 00) Equipment Conditions Engine cleaned and drained (TM 9--2350--292--20) Oil coolers, cooler frames and brackets (L.B. or R.B.) removed (TM 9--2350--292--20) Cylinder head oil drain tubes (L.B. or R.B.) removed (TM 9--2350--292--20) Smoke limiter line removed (if removing left side intake manifold and aftercooler assembly) (TM 9--2350--292--20) Equipment Conditions -- Continued Turbo outlet elbow assembly (L.B. or R.B.) removed (WP 0045 00) Starter removed (if removing left side intake manifold) (TM 9--2350--292--20) Generator vent line removed (if removing right side intake manifold and aftercooler assembly (TM 9--2350--292--20) Generator removed (if removing right side intake manifold (TM 9--2350--292--20) Manifold heater coil and lead removed (TM 9--2350--292--20) Personnel Two References TM 9--2350--292--20 Removal NOTE Replacement of the left bank and right bank intake man- ifold and aftercooler assemblies is the same. This proce- dure shows the right bank only. One of the left bank aftercooler supports is secured with two longer screws and no flat washers. These screws also secure the fuel/water separator control bracket to the engine.