TM 9--2815--247--34
0037 00--7
FUEL INJECTOR TUBES, BRACKETS, AND ASSOCIATED PARTS --
CONTINUED
0037 00
Inspection
1. Measure the inside diameter (66) of each tube assembly and discard any that are not between 0.0815--0.0865
inch (2.070 mm -- 2.197 mm).
2. Inspect tube assemblies for cracks, splits, or kinks. Discard tube assembly if damage is found.
3. Inspect compression sleeves (67), tube nuts (68), tube adapter (69), and tube fitting (70) for defects or damage.
Refer to illustration for comparison of compression sleeves (67). Discard tube assembly if damage is found.
Figure 36
68
68
69
66
66
70
NEW:
SLEEVE HAS NOT
BEEN SEATED
USED:
SLEEVE HAS BEEN SEATED
AND PROPERLY TIGHTENED--
NO DAMAGE
67
67
67
USED:
SLEEVE SERVICEABLE BUT
HAS BEEN OVERTIGHTENED--
LIMITED REUSEABLE VALUE
REMAINING
|
|
