TM 9--2815--247--34
0039 00--10
FUEL METERING PUMP ASSEMBLY REPAIR -- CONTINUED
0039 00
Installation -- Continued
12. Apply a small amount of lubricant (item 12, WP 0100 00) to machine bolt (30) and recessed washer (29).
NOTE
Lower rear bolt cannot be installed after fuel metering
pump is installed.
13. Install machine bolt (30) and recessed washer (29) in lower rear hole of fuel metering pump (2).
14. Install sling (31) on fuel metering pump (2) and then install fuel metering pump (2) in position on mounting bracket
(33).
15. Apply a small amount of lubricant (item 12, WP 0100 00) to machine bolt (28), two close tolerance bolts (26), and
three recessed washers (27 and 29).
16. Secure fuel metering pump (2) with two close tolerance bolts (26), two machine bolts (28 and 30), and four re-
cessed washers (27 and 29).
17. Tighten two close tolerance bolts (26) and machine bolts (28 and 30) to 50--52 lb--ft (68--71 NSm).
Figure 35
2
31
29
30
27
26
29
28
27
26
|
|
