TM 9--2815--247--34 0088 00--13 AUTOMATIC FUEL INJECTION ADVANCE CONTROL ASSEMBLY AND ASSOCIATED PARTS REPAIR -- CONTINUED 0088 00 Inspection -- Continued 22. Measure inside diameter (64) of bearing support (13). Replace bearing support if not within the following limits. 23. Measure outside diameter (65) of roller bearing (14). Replace roller bearing if not within the following limits. 24. Measure inside diameter (66) of roller bearing (14). Replace roller bearing if not within the following limits. 25. Measure outside diameter (67) of ball bearing (40). Replace ball bearing if not within the following limits. 26. Measure inside diameter (68) of ball bearing (40). Replace ball bearing if not within the following limits. 27. Measure inside diameter (69) of eye bracket (39). Replace eye bracket if not within the following limits. REF NO. POINT OF MEASUREMENT SIZES AND FITS OF NEW PART inches (mm) WEAR LIMITS 64 Inside diameter of bearing sup- port 3.1495 (79.9973) 3.1501 (80.0125) 3.1504 (80.0201) 65 Outside diameter of roller bearing 3.1491 (19.9871) 3.1496 (79.9998) none 66 Inside diameter of roller bearing 1.9680 (49.9872) 1.9685 (49.9999) none 67 Outside diameter of ball bearing 3.5427 (89.9846) 3.5433 (89.9998) none 68 Inside diameter of ball bearing 2.1648 (54.9859) 2.1654 (55.001) none 69 Inside diameter of eye bracket 3.5432 (89.9973) 3.5440 (90.0176) 3.5442 (90.0227) 14 13 64 65 66 67 68 40 69 39 Figure 33