TM 9--2815--247--34
0095 00--9
REAR FAN DRIVE AND ASSOCIATED PARTS REPAIR -- CONTINUED
0095 00
Assembly -- Continued
NOTE
Fan drive bevel gearshaft assembly and fan drive driven
bevel gearshaft assembly are installed with rear accesso-
ry drive housing. Refer to WP 0085 00.
8. Position original shims (20) on end of inner bearing race (side opposite bearing trade mark) of ball bearing (19).
9. Measure the total thickness (33) of bearing race and shims, from shim on inner race to upper face of outer race,
with end play removed. Thickness must be from 1.2635 inch (32.0929 mm) minimum to 1.2655 inch (32.1437
mm) maximum.
10. When total thickness is greater than 1.2655 inch (32.1437 mm), strip 0.002 inch (.0508 mm) thick laminations
from shim pack until correct thickness is obtained.
11. When total thickness is less than 1.2635 inch (32.0929 mm), add 0.002 inch (.0508 mm) thick shims (stripped
from a new shim pack) as necessary.
Figure 30
REAR FAN
DRIVEN
GEARSHAFT
BEARING
TRADEMARK
LOWER DRIVEN
GEARSHAFT
BALL BEARING
1.2635 INCHES(32.0929 MM) MIN.
1.2655 INCHES (32.1437 MM) MAX.
33
19
20
REAR FAN DRIVE
BEVEL GEARSHAFT
|
|
