TM 9-2815-250-24&P
Section II. DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE PROCEDURES
Paragraph
Page
Number
Paragraph Title
Number
3-4
Mounting Plates Replacement .............................................................................................. 3-12
3-5
Cylinder Heads Repair ......................................................................................................... 3-15
3-6
Crankcase Repair................................................................................................................ 3-20
3-7
Crankshaft and Bearings Repair........................................................................................... 3-26
3-8
Flywheel, Auxiliary Drive Hardware, and Flywheel Housing Replacement................................ 3-28
3-9
Piston and Combustion Chamber Liner Repair ...................................................................... 3-32
3-10
Rocker Arm Assemblies Repair ............................................................................................ 3-38
3-11
Camshaft Repair.................................................................................................................. 3-40
3-12
Filler Neck Replacement ...................................................................................................... 3-46
3-13
Oil Pan and Gasket Replacement ......................................................................................... 3-47
3-14
Fuel Injector Replacement.................................................................................................... 3-48
3-15
Injection Pump Replacement ................................................................................................ 3-50
3-16
Governor Control Assembly Repair....................................................................................... 3-54
3-4.
MOUNTING PLATES REPLACEMENT.
This Task Covers:
a.
Removal
b.
Cleaning
c.
Installation
Initial Setup:
Tools/Test Equipment:
Grease, automotive (Item 5, Appendix D)
General mechanic's tool kit, automotive
Rag (Item 7, Appendix D)
(Item 15, Appendix G)
Sealing compound (Item 10, Appendix D)
Screwdriver attachment, 6 mm (Item 24,
Sealing compound (Item 12, Appendix D)
Appendix G)
Lockwasher (8) (Item 23, Appendix F)
Socket wrench set, 3/8-inch drive (Item 27,
Seal (Item 48, Appendix F)
Appendix G)
Materials/Parts:
Drycleaning solvent (Item 4, Appendix D)
a.
REMOVAL
NOTE
Mark position of engine mounting plate on crankcase before removing mounting
plate from crankcase.
1.
Remove eight screws (6) and lockwashers (7) and engine mounting plate (5) from crankcase (1). Discard
lockwashers.
2.
Remove four screws (3) and mounting plate (2) from crankcase (1).
3.
Remove seal (4) from mounting plate (2). Discard seal.
3-12
|
|
