ARMY TM 9-2815-255-24 AIR FORCE TO 38G1-95-2 MARINE CORPS TM 2815-24/4 f. Remove  two  nuts  (12),  insulator  (84),  terminal  (85),  one  lockwasher  (13),  one  washer  (14),  and  two  insulator washers (15) securing solenoid (16) to cover (6); remove solenoid. NOTE Never reuse shut-off cam (17).  Always use a new one. g. Rotate shut-off arm (27) to wide open throttle (WOT) position.  Using needle nose pliers, pry gently, sliding cam (17) off shut-off shaft assembly (30). NOTE To  aid  in  correct  reassembly,  note  position  of  throttle  shaft  lever  (19)  key  in  relationship  to groove of throttle shaft assembly (18). h. Withdraw throttle shaft assembly (18) and throttle shaft lever (19) from shut-off shaft assembly (30).  Remove throttle shaft lever (19), spacer (20), two rubber seal rings (21), and two washers (22). i. If damaged, disassembly shut-off lever shaft assembly as follows: NOTE Note location of screw (23) in adjustment shut-off arm (27) and shut-off shaft assembly (30). (1) Remove  screw  (23),  adjustment  shut-off  screw  (24),  and  two  washers  (25  and  26)  securing  adjustment shut-off arm (27) to shut-off shaft assembly (30). (2) Remove two screws (28) and nuts (29) from shut-off shaft assembly (30). (3) Remove shut-off shaft assembly (30). j.  If damaged, disassemble throttle shaft assembly as follows: NOTE Note location of screw (36) in shaft assembly (18). (1) Remove screw (31), retainer (32), spring (33), lever (34), adjusting arm (35), screw (36), and spacer (37) from shaft assembly (18). (2) Remove screw (38), screw (39), and two nuts (40) from shaft assembly (18). k. Disassemble droop control (FIGURE 3-46) as follows: (1) Remove cap (1). (2) Pull adjusting cap (2) straight out.  Remove and discard seal (3). (3) Remove clip (4) from end of control rod assembly (5). (4) Remove guide (6) and washer (9). (5) Remove control rod assembly (5), spring (7), and barrel assembly (41, FIGURE 3-45). Change 3  3-84