ARMY TM 9-2815-255-24
AIR FORCE TO 38G1-95-2
MARINE CORPS TM 2815-24/4
Using lifting device, lift cylinder head (2) from block. If cylinder head sticks, use a soft hammer to tap the
Remove cylinder head gasket (3), inspect for possible oil, coolant, or combustion chamber leaks. Also, check for
evidence of incorrect or defective head gasket being used.
Do not rotate crankshaft with cylinder head removed unless all cylinder liners are secured with
cap screws and large flat washers.
Remove eight cam followers from bores in engine block and tag them as to their location for assembly purposes.
3-34.2. Inspect and Measure Prior to Disassembly.
Measure and record valve recess dimensions for all valves using a depth micrometer or magnetic base dial
Measurements should be made a maximum of 0.12 Inch (3.0 mm) In from edge of valve head OD.