ARMY TM 9-2815-255-24
AIR FORCE TO 38G1-95-2
MARINE CORPS TM 2815-24/4
FIGURE 3-14. Starter Bench Test Setup
d.
Support weight of starter and remove two screws (1, FIGURE 3-15), lockwashers (2), and washers (3) securing
starter to flywheel housing. Remove starter and discard lockwashers (2).
e.
Cover opening in flywheel housing.
f.
Bench test starter, refer to paragraph 3-12.1.
3-12.3. Disassembly.
a.
Remove nut (4, FIGURE 3-15) and washer (5).
b.
Disconnect yoke assembly lead wire (6) at magnetic switch assembly (24).
c.
Remove two through bolts (7), lockwashers (8), washers (9), and preformed packings (10). Discard lockwashers
(8) and preformed packings (10).
d.
Remove two screws (11) and starter end frame (12). Remove yoke assembly (38).
e.
Lift brush springs and remove brushes from brush holder (13). Remove brush holder assembly (13), refer to
FIGURE 3-16.
f.
Remove armature (14, FIGURE 3-15) from magnetic switch assembly (24).
g.
Remove three screws (15) from housing (16). Remove housing (16) from magnetic switch assembly (24).
Change 3 3-36
|
|
