ARMY TM 9-2815-256-24
AIR FORCE TO 38G1-96-2
MARINE CORPS TM 2815-24/5
NOTE
Retorque of cylinder head cap-screws after engine break-in is not required when
using the recommended torque procedure along with specified flanged-head
capscrews.
i.
Install pushrods and rocker arm assembly, refer to paragraph 3-33.5.
j.
Install valve cover, refer to paragraph 3-31.2.
k.
Install fuel injectors, refer to paragraph 3-29.4.
I.
Install fuel injector piping, refer to paragraph 3-26.3.
m. Install fuel filter, refer to paragraph 3-24.4.
n.
Install thermostat housing, refer to paragraph 3-9.4.
o. Install intake and exhaust manifolds, refer to paragraphs 3-15.3. and 3-14.3.
p. Install turbocharger, refer to paragraph 3-13.4.
q.
Install air intake and exhaust system, refer to end item maintenance manual.
r.
Service lubrication and coolant systems, refer to end item maintenance manual.
s.
Run engine at specified slow idle no load for 2 minutes, check for liquid leaks.
t.
Increase engine rpm to specified fast idle, then load down to 50 rpm above specified rated speed for 20 minutes.
u.
Recheck valve clearances and adjust, as necessary, refer to paragraph 3-32.1.
v.
Install valve cover, refer to paragraph 3-31.2.
3-158
|
|
