ARMY TM 9-2815-256-24
AIR FORCE TO 38G1-96-2
MARINE CORPS TM 2815-24/5
CAUTION
Once piston rings have cleared cylinder liner (9), hold on to piston to prevent piston from dropping.
3-44.2. Cylinder Liner.
a.
Measure cylinder liner height, refer to paragraph 3-46.3., step d.
b.
Remove capscrews (1, FIGURE 3-140) and washers (2) securing liners (3) to engine block.
c.
Number cylinder liners (9, FIGURE 3-143) and pistons (7). Stamp front of liner to assure correct assembly. Do
not stamp liner flange; stamp on fire dam only (raised part of liner), refer to FIGURE 3-142.
FIGURE 3-142. Marking Cylinder Liners
CAUTION
Each cylinder liner (9, FIGURE 3-143) must be reinstalled in cylinder bore from which it was
removed. Always keep matched pistons and liners together.
CAUTION
Do not over-tighten liner puller to remove liners. Doing so could easily break liners.
d.
Pull liners (9) out of engine block using suitable puller or tap liners out of engine block using a suitable wooden
block and hammer. Be sure that jaw of puller is correctly positioned before attempting to remove liner, refer to
FIGURE 3-144.
3-192
|
|
