ARMY TM 9-2815-256-24
AIR FORCE TO 38G1-96-2
MARINE CORPS TM 2815-24/5
a.
Put a bead of sealing compound (FORMAGASKET2) on oil pan rail where flywheel housing, front plate, and
timing gear cover attach to cylinder block.
b.
Place new gasket (7, FIGURE 3-52) and oil pan (6) on engine block and secure with two bolts (1), four bolts
(3), two bolts (4), eight new lockwashers (2), and twenty-eight flanged head bolts (5). Install the eight longer
bolts (1, 3 and 4) in locations noted during removal.
CAUTION
Do not overtighten oil pan-to-timing gear cover capscrews.
c.
Tighten oil pan-to-timing gear cover capscrews to 27 ft- lbs (37 Nm). Tighten all others to 35 ft-lbs (47 Nm).
d.
Service lubrication system, refer to end item maintenance manual.
3-21. OIL PUMP ASSEMBLY.
3-21.1. Removal.
a.
Remove oil pan, refer to paragraph 3-20.1.
b.
Remove nut (1, FIGURE 3-53) and pull gear (2) using a suitable puller. If a suitable puller is not available,
loosen nut (1) several turns and apply force between front plate and gear (2) on two sides of gear with a small
pry bar. Strike nut end of shaft while applying force to gear until gear is free of tapered shaft. Remove nut (1)
and gear (2).
3-70
|
|
