ARMY TM 9-2815-257-24 AIR FORCE TO 38G1-128-2 MARINE CORPS TM 10155A/2815-24/3 3-29 3-19.  STARTER MOTOR MAINTENANCE  -  cont. B.    CLEANING.   Cleaning solvents are flammable and toxic to eye, skin, and respiratory tract.  Skin and eye protections are required when working in contact with cleaning solvents.  Avoid repeated or prolonged contact.  Work in well ventilated area only.  Keep away from heat, sparks, and open flame.  Do not smoke while using cleaning solvent.  Failure to observe this warning can result in injury or death to personnel. Clean starter motor with cleaning solvent and a clean rag.  Allow to air dry. C.    INSPECTION. 1. Inspect  starter  motor  body  for  deformation,  dents,  cracks,  deformation,  or  obvious  damage.    Replace starter motor if damaged. 2. Inspect solenoid for evidence of electrical short.  Inspect electrical connection studs for corrosive damage.   Replace starter motor if any damage is suspected. D.    INSTALLATION. 1.    Install starter motor (7, Figure 3-11) into cylinder block.  Secure using two screws (8). 2.    Connect electrical wire (6) to start solenoid lug. 3.    Connect electrical wires (1, 2) to connection stud (3) using nut (4) and washer (5). WARNING