Quantcast FIGURE 5-63.  IDLER GEARS - TM-9-2815-259-24_233

Custom Search
 
  
 
ARMY TM 9-2815-259-24 AIR FORCE TO 38G1-125-2 MARINE CORPS 09249A/09246A-24 5-55 FIGURE 5-63.  IDLER GEARS c.   Test. (1) Measure upper and lower sleeve bushing (4 and 12, Figure 5-63) inner diameter.  Refer to Table 5- 4 for specifications. (2) Measure upper and lower shaft (5 and 15) outer diameter.  Refer to Table 5-4 for specifications. (3) Oil clearance is required between upper and lower bushing to shaft.  Refer to Table 5-4 for specifications.  If oil clearance exceeds limit, replace worn parts. (4) If necessary, replace worn idler gears (3 and 11 Figure 5-63), shaft (5 and 15) or bushing (4 and 12). (5) If sleeve bushings (4 and 12) were removed, use an arbor press, driver and handle to install sleeve bushing (4) in idler gear (3) and sleeve bushing (12) in idler gear (11).


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc.
6230 Stone Rd, Unit Q Port Richey, FL 34668

Phone For Parts Inquiries: (727) 493-0744
Google +