ARMY TM 9-2815-259-24P
AIR FORCE TO 38G1-125-4
MARINE CORPS TM 09249A/2815-24P/4
5. SPECIAL INFORMATION. Use the following subparagraphs as applicable:
Usable on Code. The usable on code appears in the lower left corner of the Description column heading.
Usable on codes are shown as UOC: . . . under the applicable item description/nomenclature. Uncoded items are
applicable to all models. Identification of the usable on codes used in the RPSTL are:
Diesel Engine, 4 Cylinder, Model 4045TF151
Fabrication Instructions. Bulk materials required to manufacture items are listed in the Bulk Material
Functional Group of this RPSTL. Part numbers for bulk materials are also referenced in the description column of the
line item entry for the item to be manufactured/fabricated. Detailed fabrication instructions for item source codes to
be manufactured or fabricated are found in TM 9-2815-259-24.
c. Assembly Instruction. Detailed assembly instructions f or items source coded to be assembled from
component spare/repair parts are found in TM 9-2815-259-24. Items that make up the assembly are listed
immediately following the assembly item entry or reference is made to an applicable figure.
Kits. Line item entries for repair parts kits appear throughout Section II.
Associated Publications. The publication(s) listed below pertain to this engine its components:
Maintenance Manual, Diesel Engine, Model 4045TF151
National Stock Numbers. National stock numbers (NSN's) that are missing from "P" source coded items
have been applied for and will be added to this TM by future change/revision when they are entered in the Army
Master Data File (AMDF). Until the NSN's are established and published, submit exception requisitions to:
Commander, US Army Communications-Electronics Command and Fort Monmouth, ATTN: AMSEL-LC-MM,
Fort Monmouth, NJ 07703-5007 for the part required to support your equipment.
6. HOW TO LOCATE REPAIR PARTS.
When National Stock Number or Part Number is Not Known.
First. Using the Table of Contents, determine the assembly group or subassembly group to which the
item belongs. This is necessary since figures are prepared for assembly groups and subassembly groups, and listings
are divided into the same groups.
Second. Find the figure covering the assembly group or subassembly group to which the item
Third. Identify the item on the figure and note the item number.