| Tweet |
Custom Search
|
|
|
||
 LO 9-2805-258-12
LI 03523B-10-1B
NOTES:
FOR O P E R A T I O N O F E Q U I P M E N T I N P R O T R A C T E D C O L D T E M P E R A T U R E - 1 0 F ( - 2 3 C ) . R e m o v e
1.
lubricant prescribed in table 1 for temperatures above -10 F (-23 C). Clean parts with dry cleaning solvent PD-680.
Relubricate with lubricants specified in table 1 for temperatures below -10F (-23 C). For arctic operation refer to FM
9-207.
2.
OIL CAN POINTS. Every 25 hours lubricate all exposed adjusting threads with OE/HDO.
OIL FILTER - Element/Spin-on types. Oil filters shall be serviced/cleaned/changed as applicable when:
3.
a. They are known to be contaminated, or clogged;
b. At prescribed on-condition or hard time intervals.
4.
I n S u r e cam wick is lubricated with OE/HDO (sparingly) whenever ignition contact points are replaced or
adjusted.
CRANKCASE. Drain crankcase when hot. Every 50 hours drain and refill crankcase, operate engine for five
5.
minutes, check for leaks, check crankcase oil level and bring to full mark.
Copy of this lubrication order will remain with the equipment at all times; instructions herein are mandatory.
By Order of the Secretaries of the Army and Navy (Including the Marine Corps):
GORDON R. SULLIVAN
General, United States Army
Official:
Chief of Staff
MILTON H. HAMILTON
Administrive Assistant to the
Secretary of the Army
00917
DAVID E. BOTTORFF
Rear Admiral, CEC, US Navy
Commander
Navy Facilities Engineering Command
H.E. REESE
Deputy for Support
Marine Corps Research, Development and
Acquisition
Command
DISTRIBUTION:
To be distributed in accordance with DA Form 12-25E, qty rqr block no. 4153.
1995
O
-
386-730
(02305)
PRINTING
OFFICE
:
U.S.
GOVERMENT
Card 3 of 3
|
||
|
||
