Custom Search
 
  
 
LO 9-2805-259-12
NOTES:
1.
FOR OPERATION OF EQUIPMENT IN PROTRACTED COLD TEMPERATURE -10F (-23C). Remove
lubricant prescribed in table 1 for temperatures above -10F (-23C). Clean parts with dry cleaning solvent PD-680.
Relubricate with lubricants specified in table 1 for temperatures below -10F (-23C). For arctic operation refer to FM
9-207.
2.
OIL CAN POINTS. Every 25 hours lubricate all exposed adjusting threads with OE/HDO.
3.
OIL FILTER - Element/Spin-on types.  Oil filters shall be serviced/cleaned/changed as applicable when:
a. They are known to be contaminated, or clogged;
b. At prescribed on-condition or hard time intervals.
4.
Insure cam wick is lubricated with OE/HDO (sparingly) whenever ignition contact points are replaced or
adjusted.
5.
CRANKCASE. Drain crankcase when hot. Every 50 hours drain and refill crankcase, operate engine for five
minutes, check for leaks, check crankcase oil level and bring to full mark.
Copy of this lubrication order will remain with the equipment at all times; instructions herein are mandatory.
By Order of the Secretaries of the Army and Navy (Including the Marine Corps):
GORDON R. SULLIVAN
General, United States Army
Official:
Chief of Staff
MILTON H. HAMILTON
Administrative Assistant to the
Secretary of the Army
00441
DAVID E. BOTTORFF
Rear Admiral, CEC, US Navy
Commander
Navy Facilities Engineering Command
H.E. REESE
Deputy for Support
Marine Corps Research, Development and
Acquisition Command
DISTRIBUTION:
To be distributed in accordance with DA Form 12-25E, qty rqr block no. 4155.
Card 3 of 3


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business