| Tweet |
Custom Search
|
|
|
||
 3500 ENGINE
SPECIFICATIONS
FUEL INJECTION CONTROL GROUP
(1) Bore of the bearings in the bracket assemblies (after
(4)
Clearance between the lever assemblies on the
assembly)
front cross shaft and the side shafts
................ 21.925 + 0.015 mm (.8632 + .0006 in.)
..........................0 80 0.10 mm (.031 + .004 in.)
(2) Diameter of the surfaces for the bearings and rod
(5)
Tighten locknuts at each end of bellcrank to a
torque of .......................... 8 + 2 N-m (6 + 1 lb. ft.)
assemblies on the shafts
................ 21.850 + 0.015 mm (.8602 + .0006 In )
(3)
Bore of the bearings in the two support
assemblies (after
assembly} 21.925 + 0.015 mm (.8632 + .0006 in.)
10
|
||
|
||
