| Tweet |
Custom Search
|
|
|
||
 3500 ENGINE
SPECIFICATIONS
CAMSHAFTS
(1)
Thickness of washer
(new).................. 8.50 + 0 05 mm (335 + .002 in.)
Thickness of groove In camshaft
(new).................. 8.75 + 0 05 mm( 344 .002 in.)
End play for the camshafts
(new)............... 0.15 to 0.35 mm (.006 to .014 in.)
(2)
L. H. camshaft.
(3)
R. H. camshaft.
(4)
Diameter of the surfaces (journals) for the
camshaft bearings (new)
...................... 85.88 + 0.02 mm (3.381 + .001 in.)
Bore in the bearings for the camshafts (after
assembly) ..... 86.00 + 0.06 mm (3.386 + .002 in.)
(5)
Height of camshaft lobes. To find lobe height,
use the procedure that follows:
A Measure camshaft lobe height (5).
B Measure base circle (7).
C. Subtract base circle (STEP B) from lobe
height (STEP A) The difference is actual lobe
lift.
D.
Specified camshaft lobe lift (6) is:
a. Exhaust lobe.................. 9.078 mm ( 3574 in.)
b. Intake lobe ..................... 9.314 mm (.3667 in.)
c. Injector lobe ................. 13.678 mm ( 5385 in.)
12
|
||
|
||
