| Tweet |
Custom Search
|
|
|
||
 3500 ENGINE
SPECIFICATIONS
AIR INTAKE SHUTOFF
(1)
Hydraulic shutoff cylinder. Make an alignment of cylinder port and vent hole (9) in a vertical downward position at
assembly.
(2)
Torque for nut that holds cylinder
(1) to the flange ............................ 45 7 Nm (33 5 lb. ft.)
(3)
Diameter of cylinder
..................................... 7.920 0.013 mm (.3118 .0005 in.)
rod
Bore in bushing after
assembly ..................................... 7.996 0.044 mm (.3148 .0017 in.)
Bore in housing for
bushing ..................................... 9.525 0.013 mm (.3750 .0005 in.)
Install bushing with split along centerline (8) toward front or rear.
(4)
2V244 Spring for shutoff actuator pin:
Length under test force ................ 29.2 mm (1.15 in.)
Test force ....... 8.9 0.7 N (2.00 .16 lb.)
Free length after test .................... 54.6 mm (2.15 in.)
Outside diameter
..................... 9.04 mm (.356 in.)
(5)
Torque for carrier (put 2P2506 Thread Lubricant
on the threads) ............................. 70 10 Nm (50 7 lb. ft.)
Bore in spring bushing.................. 19.30 0.25 mm (.760 .010 in.)
(6)
..................... 18.97 0.02 mm (.747 .001 in.)
Diameter of shaft
..................... 18.97 0.02 mm (.747 .001 in.)
(7)
Diameter of shaft
Bore in two shaft bushings
..................... 19.050 0.044 mm (.7500 + .0017 in.)
(after assembly)
Bore in housing for
bushings ....... .22.205 0.013 mm (.8742 0005 in.)
24
|
||
|
||
