| Tweet |
Custom Search
|
|
|
||
 3500 ENGINE
SPECIFICATIONS
FRONT BALANCER GROUP
(1)
Balancer gear.
(2)
Diameter of shaft
(new) .................................. 74 900 + 0 015 mm (2 9488 + .0006 in )
Bore in bearing (after
assembly) ........................... 75 000 + 0.053 mm (2 9528 + .0021 in )
Bearing joint must be in center of heavy section in gear at
assembly.
(3)
Balancer gear marks must be in alignment with crankshaft gear marks as shown for SAE
standard rotation engines
(4)
Balancer gear marks must be in alignment with crankshaft gear marks as shown for SAE
opposite rotation engines
(5)
Crankshaft gear.
NOTE: FOR TORQUE VALUES NOT GIVEN, SEE THE FIRST
PAGE OF SPECIFICATIONS FOR GENERAL TIGHTENING TORQUES
41
|
||
|
||
