| Tweet |
Custom Search
|
|
|
||
 3500 ENGINE
SPECIFICATIONS
Flywheel Runout (Cont.)
Bore Runout (radial eccentricity) of the Flywheel:
1
Install the dial indicator (3) and make an
adjustment of the universal attachment (4) so
it makes contact as shown.
2.
Set the dial indicator to read 0.0 mm (.00 in.)
3.
Turn the flywheel and read the indicator every
90
4.
The difference between the lower and higher
measurements taken at all four points must not
be more than 0 15 mm (.006 in ), which is the
maximum permissible bore runout (radial
eccentricity)
of the flywheel.
5.
Runout (eccentricity) of the bore for the pilot
bearing for the flywheel clutch, must not exceed
0.13 mm ( 005 in )
CHECKING FLYWHEEL BORE
CHECKING FLYWHEEL CLUTCH
PILOT BEARING BORE
NOTE: FOR TORQUE VALUES NOT GIVEN, SEE THE FIRST
PAGE OF SPECIFICATIONS FOR GENERAL TIGHTENING TORQUES
49
|
||
|
||
