| Tweet |
Custom Search
|
|
|
||
 3500 ENGINES
DISASSEMBLY AND ASSEMBLY
WATER PUMP
8.
Remove ceramic seal (11) from the rubber ring.
Remove the rubber ring from housing assembly
(2).
9.
Remove seal (12) from the back of housing
assembly (2).
ASSEMBLE WATER PUMP
1361-16
Tools Needed
A
1P510 Driver Group
1
1.
If necessary, make a replacement of the two
filters in the pump housing at location (1).
2.
If necessary, make a replacement of plug (2)
and the seal.
3.
Use tool group (A) to install the seal in the
housing assembly. Make sure the lip of the seal
is toward the outside as shown. Put clean
engine oil on the lip of the seal.
4.
Install shaft assembly (3) in housing assembly
(4). Install washer (5) and the bolts to hold shaft
assembly (3) in position.
NOTICE
Clean water only is permitted for use as a lubricant
for assembly. Do not damage or put hands on the
wear surface of the carbon ring or the ceramic ring.
Install the ceramic ring with the smoothest face of
the ring toward the carbon seal assembly.
5.
Put ceramic seal (6) in position in the rubber
ring. Use hand pressure and the tool (which is
with the replacement seal) to install the ceramic
seal.
277
|
||
|
||
