| Tweet |
Custom Search
|
|
|
||
 3500 ENGINES
DISASSEMBLY AND ASSEMBLY
HYDRAMECHANICAL SHUTOFF CONTROL
ASSEMBLE
HYDRAMECHANICAL
SHUTOFF
CONTROL
Tools Needed
A
B
C
1P510
Driver Group
1
1P1853
Pliers
1
1 1P1855
Pliers
1
1.
If necessary, make a replacement of dowels (2)
and make sure they are 3.0 + 0.5 mm (.118. +
.020 in.) above the surface of the housing
assembly.
2.
Put guide (I) in position in the housing assembly
and make sure the dash mark on the end of, the
guide is in alignment with hole (3). Use tool
group (A) to install guide (I) in the housing
assembly.
3.
Put lever (5) in position in the housing assembly
as shown and install shaft (4) to hold lever (5) in
position. Make sure the end of the shaft is, a
even (flush) + 0.25 (.010 in.) with the housing
assembly.
4.
Put the seat, spring (7) and seat (6) in position in
cover (8) and put cover (8) and the gasket in
position on the housing assembly. Install the
bolts to hold the cover in position.
5.
Install nut (15) and seat (10) on speed sensing
valve (9). Make sure the dimension between the
end of the valve and the nut face of the seat is
117.21 + 0.25 mm (4.614 + .010 in.) and tighten
the nut. Put race (14), bearing (11) and race
(13) in position on seat (10) and install ring (12)
to hold these in position.
340
|
||
|
||
