| Tweet |
Custom Search
|
|
|
||
 3500 ENGINES
DISASSEMBLY AND ASSEMBLY
ACCESSORY DRIVE (FRONT)
REMOVE ACCESSORY DRIVE
(FRONT)
1207-11
start by:
a) remove governor drive
b) remove alternator (if so equipped)
1.
Remove the bolts and remove cover (1) from
adapter assembly (2).
2.
Use two 1/2"-13 NC forcing screws to remove
adapter assembly (2) from the front drive hous-
ing.
3.
Remove the bolts and remove adapter assembly
(3), the drive gear and shaft as a unit from the
front drive housing.
INSTALL ACCESSORY DRIVE
(FRONT)
1207-12
1.
Make sure the two O-ring seals are in position
on adapter assembly (1) and put clean engine oil
on them.
2.
Install the drive shaft, gear and adapter assem-
bly (1) in the front drive housing. Make sure the
teeth of the accessory drive gear are correctly
engaged with the teeth of the oil and water pump
drive gear and install the bolts to hold adapter
assembly (1) in position.
3.
Make sure the two O-ring seals are installed on
adapter assembly (2) and put clean engine oil on
the seals. Put clean oil on the lip of the seal and
bearing in adapter assembly (2) and install the
adapter assembly. Tighten the bolts to hold
adapter assembly (2) in position.
4.
Install the cover on adapter assembly (2).
end by:
a) install governor drive
b) install alternator (if equipped)
347
|
||
|
||
