| Tweet |
Custom Search
|
|
|
||
 3500 ENGINES
DISASSEMBLY AND ASSEMBLY
ACCESSORY DRIVE (FRONT)
ASSEMBLE ACCESSORY DRIVE
(FRONT)
1207-16
Tools Needed
A
1P520
Driver Group
1
1.
Make an alignment of the oil hole in the bearing
and the oil hole in adapter (1). Use a press and
tool group (A) and install the bearing in adapter
(1).
Check the bore in the bearing after
assembly. The bore in the bearing must be
75.000 0.055 mm (2.9528 .0022 in.).
2.
Install the two O-ring seals in adapter (1).
3.
Put clean engine oil on the bearing and install
shaft (3) in adapter (1). Install retainer washer
(2) to hold the shaft and adapter together.
4.
Put gear (4) in position on shaft (3) and install
the bolts to hold them together.
5.
Make an alignment of the oil hole in the bearing
and the oil hole in adapter (5). Use a press and
tool group (A) and install the bearing in adapter
(5).
Check the bore in the bearing after
assembly. The bore in the bearing must be
75.000 0.055 mm (2.9528 .0022 in.).
6.
Use tool group (A) to install the seal in adapter
(5). Make sure the lip of the seal is toward the
bearing as shown.
7.
Install 0-ring seals (6) and (7) on adapter (5) and
put clean engine oil on them.
end by:
a) install accessory drive (front)
349
|
||
|
||
