| Tweet |
Custom Search
|
|
|
||
 3500 ENGINES
DISASSEMBLY AND ASSEMBLY
OIL AND WATER PUMP DRIVE
ASSEMBLE OIL AND WATER
PUMP DRIVE
1313-16
Tools Needed
A
1P520
Driver Group
1
1.
Lower the temperature of the bearing for water
pump adapter (1). Use tool group (A) and install
the bearing in adapter (1). Check the bore in the
bearing after assembly. The bore in the bearing
must be 75.00 0.06 mm (2.953 .002 in.).
Install O-ring seal (2) on adapter (1).
2.
Put gears (3) and (4) in position on the shaft
assembly as shown and install the bolts to hold
the unit together.
3.
Lower the temperature of the bearing for adapter
(5). Make an alignment of the oil hole in the
bearing with the oil hole in adapter (5) and use
tool group (A) to install the bearing. Make sure
the bearing does not extend beyond the surface
shown and the inside diameter is 75.00 0.06
mm (2.953 .002 in.) after installation.
4.
Install O-ring seals (6) and (7) on adapter (5).
5.
Put adapter (5) in position on shaft assembly (8)
and install washers (9) to hold the unit together.
6.
Install the oil pump O-ring seal (10) on adapter
(5).
end by:
a) install oil and water pump drive
352
|
||
|
||
