| Tweet |
Custom Search
|
|
|
||
 3500 ENGINES
DISASSEMBLY AND ASSEMBLY
FRONT BALANCER GROUP (3508)
INSTALL FRONT BALANCER GROUP
Tools Needed
A
1P520
Driver Group
1
1.
Put crank gear (2) in position on the end of the
crankshaft and install the bolts.
2.
Install shaft (1) on the end of the cylinder block.
3.
Use tool group (A) and a press to install the
bearing in balancer gear (3). Make sure the
bearing joint is in the center of the heavy section
in gear (3). The bore in the bearing must be
75.00 + 0.053 mm (2.9528 + .0021 in.) after
assembly.
4.
Put balancer gear (3) in position on the shaft.
Make sure the marks on the balancer gear and
the crank gear are in alignment according to the
rotation of the engine as shown.
5.
Install plate (4) and the bolts to hold it on the
balancer gear.
6.
Put shaft (7) in position on the cylinder block.
Make sure the levers on shaft (7) are correctly
engaged with the levers on shafts (5) and (6) and
install the bolts to hold the brackets and shaft (7)
to the cylinder block.
end by:
a) install front drive housing
386
|
||
|
||
