| Tweet |
Custom Search
|
|
|
||
 3500 ENGINES
DISASSEMBLY AND ASSEMBLY
REAR GEAR GROUP
6.
Use tool group (A) and a press to install bearing
(6) in gear assembly (7). The bore in bearing (6)
must be 75.00 0.053 mm (2.9528 .0021 in.)
after assembly.
7.
Heat the larger gear of gear assembly (7) to a
maximum temperature of 400 C (752 F) and
install it on the smaller gear as shown.
8.
Put clean engine oil on the bearing and install
gear assembly (7) on the shaft.
NOTE: Step 9 is for the 3508 Engine.
9.
Put clean engine oil on the bearing and install
the gear assembly on the shaft. Make sure the
marks on the gear assembly and the crankshaft
gear are in alignment according to the rotation of
the engine as shown.
10.
Put plate (8) in position on gear assembly (7)
and install the bolts.
end by:
a) install flywheel housing
390
|
||
|
||
