| Tweet |
Custom Search
|
|
|
||
 3500 ENGINE ATTACHMENTS
SPECIFICATIONS
AIR COMPRESSOR GROUP
(8N8360)
(6)
Nut. Tightened the nut to a
(1)
Air compressor.
torque of ............................ 135 Nm (100 lb. Ft.)
(2)
Bore in bearing (after
If the cotter pin can not be installed, tighten the
assembly)
nut more to make an alignment of the nearest
.............75.000 + 0.055 mm (2.9528 + .0022 in.)
slot in the nut with the hole in the shaft.
(3)
O-ring seal.
(7)
Seal. Install the seal in adapter assembly (4)
Diameter of drive shaft (new)
with the bearing as shown.
.....74.900 + 0.015 mm (2.9488 + .0006 in.)
(8)
V-Belt. Tighten the V-Belt to the specifications
given in the V-BELT TENSION CHART.
(4)
Adapter assembly.
NOTE: Put clean engine oil on O-ring seal (3) and the lip
(5)
Governor. The governor air pressure range is
of seal (7) at assembly.
.................... 620 to 795 kPa (90 to 115 psi)
NOTE: FOR TORQUE VALUES NOT GIVEN, SEE THE FIRST
PAGE OF SPECIFICATIONS FOR GENERAL TIGHTENING TORQUES
457
|
||
|
||
